Arp Timeout - Dell MXL 10GbE Reference Manual

Usage Retries are 20 seconds apart.
Information
Related show arp retries
Commands

arp timeout

Set the time interval for an ARP entry to remain in the ARP cache.
Syntax
arp timeout minutes
Parameters
minutes
Defaults 240 minutes (4 hours)
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Related show interfaces
Commands
clear arp-cache
Clear the dynamic ARP entries from a specific interface or optionally delete (no-refresh) ARP entries
from the content addressable memory (CAM).
Syntax
clear arp-cache [interface | ip ip-address] [no-refresh]
Parameters
interface
IPv4 Routing
— displays the configured number of ARP retries.
Enter the number of minutes. The range is from 0 to 35790.
The default is 240 minutes.
Introduced on the MXL 10/40GbE Switch IO Module.
— displays the ARP timeout value for all available interfaces.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN, enter the keyword vlan then a number from
1 to 4094.
615