capture bgp-pdu max-buffer-size
Set the size of the BGP packet capture buffer. This buffer size pertains to both IPv4 and IPv6 addresses.
Syntax
capture bgp-pdu max-buffer-size 100-102400000
Parameters
100-10240000
0
Defaults
40960000 bytes
Command
•
Modes
•
Command
Version 9.2(0.0)
History
Related
capture bgp-pdu neighbor (ipv6)
Commands
reflector and the clients.
show capture bgp-pdu neighbor
clear ip bgp * (asterisk)
Reset all BGP sessions in the specified category. The soft parameter (BGP Soft Reconfiguration) clears the
policies without resetting the TCP connection.
Syntax
clear ip bgp * [ipv4 multicast soft [in | out] | ipv6 unicast
soft [in | out] | soft [in | out]]
Parameters
*
ipv4 multicast
soft [in | out]
ipv6 unicast
soft [in | out]
soft
in
708
Enter a size for the capture buffer.
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
Enter an asterisk ( * ) to reset all BGP sessions.
(OPTIONAL) Enter the keywords ipv4 multicast soft
[in | out] to set options within the specified IPv4 address
family.
(OPTIONAL) Enter the keywords ipv6 multicast soft
[in | out] to set options within the specified IPv6 address
family.
(OPTIONAL) Enter the keyword soft to configure and
activate policies without resetting the BGP TCP session, that
is, BGP Soft Reconfiguration.
(OPTIONAL) Enter the keyword in to activate only inbound
policies.
— enables route reflection between the route
— configures a route reflector and clients.
NOTE: If you enter clear ip bgp ip6-address
soft, both inbound and outbound policies are reset.
IPv6 Border Gateway Protocol (IPv6 BGP)