Vrrp Delay Reload - Dell MXL 10GbE Reference Manual

•
•
Related

vrrp delay reload

Command
vrrp delay reload
Set the delay time for VRRP initialization after a system reboot.
Syntax
vrrp delay reload seconds
Parameters
seconds
Defaults 0
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
Usage
This command applies to all the VRRP configured interfaces on a system. When
Information
used with the vrrp delay minimum CLI, the later timer rules the VRRP enabling.
For example, if vrrp delay reload is 600 and the vrrp delay minimum is
300:
•
•
Save the configuration and reload the system for the delay timers to take effect.
Related vrrp delay minimum
Command reboot.
vrrp-group
Assign a VRRP ID to an interface. You can configure up to 12 VRRP groups per interface.
Syntax
vrrp-group vrrp-id
1356
When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
— sets the delay time for VRRP initialization after a system reboot.
Enter the number of seconds for the delay. The range is from
0 to 900 (0 indicates no delay).
Introduced on the MXL 10/40GbE Switch IO Module.
When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up
VRRP on all interfaces that are up and configured for VRRP.
When an interface comes up, whether as part of a system reload or an interface
reload, the system waits 300 seconds (5 minutes) to bring up VRRP on that
interface.
— sets the delay time for VRRP initialization after a line card
Virtual Router Redundancy Protocol (VRRP)