Description - Dell MXL 10GbE Reference Manual

Use this command to match an IP class-map against a single VRF ID .
Related class-map
Commands

description

Add a description to the selected policy map or QoS policy.
Syntax
description {description}
To remove the description, use the no description {description}
command.
Parameters
description
Defaults none
Command CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in
Modes and conf-qos-policy-out; wred)
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Related
policy-map-output
Commands
qos-policy-output
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
Syntax
match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp value]
To remove a DSCP value as a match criteria, use the no match {ip | ipv6 |
ip-any} dscp dscp-list [[multicast] set-ip-dscp value] command.
Parameters
ip
ipv6
ip-any
1084
— identifies the class map.
Enter a description to identify the policies (80 characters
maximum).
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— creates an output policy map.
— creates an output QoS-policy on the router.
Enter the keyword ip to support IPv4 traffic.
Enter the keyword ipv6 to support IPv6 traffic
Enter the keyword ip-any to support IPv4 and IPv6 traffic.
Quality of Service (QoS)