Interface Te; Storm-Control Broadcast (Configuration) - Dell MXL 10GbE Reference Manual

Parameters
interface
Defaults none
Command
•
Modes
•
Command
Version 8.3.16.1
History
Example
Dell#show storm-control unknown-unicast tengigabitethernet 3/0
Unknown-unicast storm control configuration
Interface
----------------------------------------
TenGig 3/0
Dell#

storm-control broadcast (Configuration)

Configure the percentage of broadcast traffic allowed in the network.
Syntax
storm-control broadcast [packets_per_second in]
To disable broadcast rate-limiting, use the no storm-control broadcast
[packets_per_second in] command.
Parameters
packets_per_se
cond
Defaults none
Command CONFIGURATION (conf)
Modes
Command
Version 8.3.16.1
History
Usage Broadcast storm control is valid on Layer 2/Layer 3 interfaces only. Layer 2
Information broadcast traffic is treated as unknown-unicast traffic.
1266
(OPTIONAL) Enter one of the following interfaces to display
the interface specific storm control configuration:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/ port information.
EXEC
EXEC Privilege
Introduced on MXL 10/40GbE Switch IO Module
Direction
Ingress
Enter the packets per second of broadcast traffic allowed
into the network. The range is from 0 to 33554368.
Introduced on the MXL 10/40GbE Switch IO Module.
Packets/Second
1000
Storm Control