Description - Dell MXL 10GbE Reference Manual

Version
8.3.12.0
Version 8.4.2.3
Related clear ufd-disable
Commands Error state.

description

Enter a text description of an uplink-state group.
Syntax
description text
Parameters
text
Defaults none
Command UPLINK-STATE-GROUP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version
8.3.12.0
Version 8.4.2.3
Example
Dell(conf-uplink-state-group-16)# description test
Dell(conf-uplink-state-group-16)#
Related uplink-state-group— creates an uplink-state group and enables the tracking of
Commands upstream links.
downstream
Assign a port or port-channel to the uplink-state group as a downstream interface.
Syntax
downstream interface
To delete an uplink-state group, enter the no downstream interface
command.
1522
Introduced on the S4810.
Introduced on the S-Series S50.
— re-enables downstream interfaces that are in a UFD-Disabled
Text description of the uplink-state group. The maximum
length is 80 alphanumeric characters.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series S50.
PMUX Mode of the MXL 10/40GbE Switch I/O Module