Ip Pim Spt-Threshold - Dell MXL 10GbE Reference Manual

Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Usage This command configures an expiration timer for all S.G entries, unless they are
Information assigned to an Extended ACL.

ip pim spt-threshold

To switch to the shortest path tree when the traffic reaches the specified threshold value, configure the
PIM router.
Syntax
ip pim spt-threshold value | infinity
To return to the default value, use the no ip pim spt-threshold command.
Parameters
value
infinity
Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Usage This command is applicable to last hop routers on the shared tree towards the
Information rendezvous point (RP).
no ip pim snooping dr-flood
Disable the flooding of multicast packets to the PIM designated router.
Syntax
no ip pim snooping dr-flood
To re-enable the flooding of multicast packets to the PIM designated router, use
the ip pim snooping dr-flood command.
Defaults Enabled.
1022
Introduced on the MXL 10/40GbE Switch IO Module.
(OPTIONAL) Enter the traffic value in kilobits per second. The
default is 10 packets per second. A value of zero (0) causes a
switchover on the first packet.
(OPTIONAL) Enter the keyword infinity to never switch to
the source-tree.
Introduced on the MXL 10/40GbE Switch IO Module.
PIM-Sparse Mode (PIM-SM)