Iscsi Profile-Compellant - Dell MXL 10GbE Reference Manual

Version 8.3.16.1

iscsi profile-compellant

Configure the auto-detection of Dell Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults Dell Compellent disk arrays are not detected.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is
monitored.
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-
address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi
target port command.
Parameters
tcp-
port-2...tcpport
- 16
ip-address
Defaults 860, 3260
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
788
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the tcp-port number of the iSCSI target ports. The
tcp-port-n is the TCP port number or a list of TCP port
numbers on which the iSCSI target listens to requests.
Separate port numbers with a comma. The default is 860,
3260.
(Optional) Enter the ip-address that the iSCSI monitors. The
ip-address specifies the IP address of the iSCSI target.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
iSCSI Optimization