Service-Class Dot1P-Mapping - Dell MXL 10GbE Reference Manual

assigned to the port channel are automatically configured; you cannot assign the
service-class dynamic command to individual interfaces in a port channel.
•
•

service-class dot1p-mapping

Configure a service-class criterion based on a dot1p value.
Syntax
service-class dot1p-mapping {dot1p0 value | dot1p1 value |
dot1p2 queue | dot1p3 value | dot1p4 value| dot1p5 value |
dot1p6 value | dot1p7 value}
Parameters
value
Defaults For each dot1p Priority, the default CoS queue value is:
•
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
PMUX Mode of the MXL 10/40GbE Switch I/O Module
All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command on an interface or globally.
Layer 2 or Layer 3 service policies supersede dot1p service classes.
Enter a dot1p list number and value. The list number range is
from 0 to 7. The range is from 0 to 3.
dot1p CoS Queue
0 0-7
1 0-7
2 0-7
3 0-7
4 0-7
5 0-7
6 0-7
7 0-7
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
1503