Iscsi Aging Time - Dell MXL 10GbE Reference Manual

Usage You can configure iSCSI TLVs to send either globally or on a specified interface.
Information The interface configuration takes priority over global configuration.

iscsi aging time

Set the aging time for iSCSI sessions.
Syntax
iscsi aging time time
To remove the iSCSI session aging time, use the no iscsi aging time
command.
Parameters
time
Defaults 10 minutes
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
iscsi cos
Set the QoS policy that is applied to the iSCSI flows.
Syntax
iscsi cos {enable | disable | dot1p vlan-priority-value
[remark] | dscp dscp-value [remark]}
To disable the QoS policy, use the no iscsi cos dscp command.
Parameters
enable
disable
dot1p vlan-
priority-value
1460
Enter the aging time for the iSCSI session. The range is from
5 to 43,200 minutes.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the keyword enable to allow the application of
preferential QoS treatment to iSCSI traffic so that the iSCSI
packets are scheduled in the switch with a dot1p priority 4
regardless of the VLAN priority tag in the packet. The default
is: the iSCSI packets are handled with dotp1 priority 4
without remark.
Enter the keyword disable to disable the application of
preferential QoS treatment to iSCSI frames.
Enter the dot1p value of the VLAN priority tag assigned to the
incoming packets in an iSCSI session. The range is from 0 to
7. The default is the dot1p value in ingress iSCSI frames is not
changed and is the same priority is used in iSCSI TLV
advertisements if you did not enter the iscsi priority-
bits command.
PMUX Mode of the MXL 10/40GbE Switch I/O Module