Quality Of Service (Qos) - Dell MXL 10GbE Reference Manual

Quality of Service (QoS)

The Dell Networking operating software commands for quality of service (QoS) include traffic
conditioning and congestion control. QoS commands are not universally supported on all Dell
Networking Products.
Per-Port QoS Commands
Per-port QoS (port-based QoS) allows you to define the QoS configuration on a per-physical-port basis.
dot1p-priority
Assign a value to the IEEE 802.1p bits on the traffic this interface receives.
Syntax
dot1p-priority priority-value
To delete the IEEE 802.1p configuration on the interface, use the no dot1p-
priority command.
Parameters
priority-value
Defaults none
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
The dot1p-priority command changes the priority of incoming traffic on the
Information
interface. The system places traffic marked with a priority in the correct queue and
processes that traffic according to its queue.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Enter a value from 0 to 7.
dot1p Queue Number
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
1501