Keepalive - Dell MXL 10GbE Reference Manual

Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
If you configure interface type as CR4 with auto-negotiation enabled, also
Information
configure CR4 with auto-negotiation. Many DAC cable link issues are resolved by
setting the interface type as CR4.
Related
interface
Commands
interface port-channel

keepalive

Send keepalive packets periodically to keep an interface alive when it is not transmitting data.
Syntax
keepalive [seconds]
To stop sending keepalive packets, use the no keepalive command.
Parameters
seconds
Defaults Enabled.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage When you configure keepalive, the system sends a self-addressed packet out of
Information the configured interface to verify that the far end of a WAN link is up. When you
configure no keepalive, the system does not send keepalive packets and so the
local end of a WAN link remains up even if the remote end is down.
570
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— configures a physical interface.
— configures a port channel group.
(OPTIONAL) For interfaces with PPP encapsulation enabled,
enter the number of seconds between keepalive packets.
The range is from 0 to 23767. The default is 10 seconds.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Interfaces