Dell MXL 10GbE Reference Manual page 1049

interface
direction {rx | tx
| both}
Defaults none
Command MONITOR SESSION (conf-mon-sess-session-ID)
Modes
Command
Version 9.4(0.0)
History
Version 8.3.16.1
Example
Dell# monitor session 0
source Port-channel 10 destination TenGigabitEthernet 0/33
direction tx
Port Monitoring
• For a port channel interface, enter the keyword LAG then
port channel and the port-channel id .
Enter the one of the following keywords and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface enter the keyword VLAN followed by
a number from 1 to 4094.
• For a port channel interface, enter the keyword LAG then
port channel and the port-channel id .
Enter the keyword direction then one of the packet
directional indicators.
• rx: to monitor receiving packets only.
• tx: to monitor transmitting packets only.
• both: to monitor both transmitting and receiving
packets.
Added support for Source and destination.
Introduced on the M I/O Aggregator.
1049