Ipv6 Ospf Dead-Interval - Dell MXL 10GbE Reference Manual

Using this formula, the default path cost is calculated as:
•
•
•
•

ipv6 ospf dead-interval

Set the time interval since the last hello-packet was received from a router. After the time interval elapses,
the neighboring routers declare the router down.
Syntax
ipv6 ospf dead-interval seconds
Parameters
seconds
Defaults 40 seconds (Ethernet).
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Usage
By default, the dead interval is four times longer than the default ipv6 ospf
Information
hello-interval command.
ipv6 ospf encryption
Configure an IPsec encryption policy for OSPFv3 packets on an IPv6 interface.
Syntax
ipv6 ospf encryption {null | ipsec spi number esp encryption-
algorithm [key-encryption-type] key athentication-algorithm
[key-encryption-type] key}}
To remove an IPsec encryption policy from an interface, use the no ipv6 ospf
encryption spi number command.
To remove null authentication on an interface to allow the interface to inherit the
authentication policy configured for the OSPFv3 area, use the no ipv6 ospf
encryption null command.
992
GigabitEthernet—Default cost is 1
TenGigabitEthernet—Default cost is 1
FortygigEthernet — Default cost is 1
Ethernet—Default cost is 10
Enter the time interval in seconds. The range is from 1 to
65535 seconds.
Introduced on the MXL 10/40GbE Switch IO Module.
Open Shortest Path First (OSPFv2 and OSPFv3)