Table of Contents
Advertisement
count value
interface
Command
EXEC Privilege
Modes
Command
Version 8.3.16.1
History
Usage
The following describes the debug ip packet command in the following
Information
example.
Field
s=
d=
len
sending, rcvd,
fragment, sending
broad/multicast
proto, unroutable
TCP src=
UDP src=
ICMP type=
IP Fragment
IPv4 Routing
(OPTIONAL) Enter the keyword count then the count value.
The range is from 1 to 65534. The default is Infinity.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
•
For the Management interface, enter the keyword
ManagementEthernet then the slot/port information.
The slot range is from 0 to 1 and the port range is 0.
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from
1 to 4094.
Introduced on the MXL 10/40GbE Switch IO Module.
Description
Lists the source address of the packet and the name of the
interface (in parentheses) that received the packet.
Lists the destination address of the packet and the name of
the interface (in parentheses) through which the packet is
being sent out on the network.
Displays the packet's length.
The last part of each line lists the status of the packet.
Displays the source and destination ports, the sequence
number, the acknowledgement number, and the window
size of the packets in that TCP packets.
Displays the source and destination ports for the UDP
packets.
Displays the ICMP type and code.
States that it is a fragment and displays the unique number
identifying the fragment (Ident) and the offset (in 8-byte
621
Advertisement
Table of Contents
