Debug Uplink-State-Group - Dell MXL 10GbE Reference Manual

•
•

debug uplink-state-group

Enable debug messages for events related to a specified uplink-state group or all groups.
Syntax
debug uplink-state-group [group-id]
To turn off debugging event messages, enter the no debug uplink-state-
group [group-id] command.
Parameters
group-id
Defaults none
Command EXEC Privilege
Modes
Command
Version 8.3.16.1
History
Related clear ufd-disable
Commands Error state.
description
Enter a text description of an uplink-state group.
Syntax
description text
Parameters
text
Defaults none
Command UPLINK-STATE-GROUP
Modes
Command
Version 8.3.16.1
History
Example
Dell(conf-uplink-state-group-3)#description Testing UFD feature
Dell(conf-uplink-state-group-3)#show config
!
1314
upstream — assigns a port or port-channel to the uplink-state group as an
upstream interface.
uplink-state-group — creates an uplink-state group and enables the tracking of
upstream links.
Enables debugging on the specified uplink-state group. The
valid group-id values are from 1 to 16.
Introduced on the MXL 10/40GbE Switch IO Module.
— re-enables downstream interfaces that are in a UFD-Disabled
Text description of the uplink-state group. The maximum
length is 80 alphanumeric characters.
Introduced on the MXL 10/40GbE Switch IO Module.
Uplink Failure Detection (UFD)