Match Mac Access-Group - Dell MXL 10GbE Reference Manual

ip-any
ip-
precedence-list
set-ip-dscp
value
Defaults none
Command CLASS-MAP CONFIGURATION (config-class-map)
Modes
Command
Version 9.5(0.0)
History
Version 8.3.16.1
Usage
To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria.
The match ip precedence command and the match ip dscp command are
mutually exclusive.
Up to eight precedence values can be matched in one match statement. For
example, to indicate the IP precedence values 0 1 2 3, enter either the match ip
precedence 0-3 or match ip precedence 0,1,2,3 command.
Related class-map
Commands

match mac access-group

Configure a match criterion for a class map, based on the contents of the designated MAC ACL.
Syntax
match mac access-group {mac-acl-name}
Parameters
mac-acl-name
Defaults none
1086
Enter the keyword ip-any to support IPv4 and IPv6 traffic.
Enter the IP precedence value(s) as the match criteria.
Separate values by commas — no spaces ( 1,2,3 ) or indicate
a list of values separated by a hyphen (1-3). The range is from
0 to 7.
(OPTIONAL) Enter the keywords set-ip-dscp then the IP
DSCP value. The matched traffic is marked with the DSCP
value. The range is from 0 to 63.
Introduced the support for ipv6 and ip-any options on the
MXL 10/40GbE Switch.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Only one of the IP precedence values must be a successful match
criterion, not all of the specified IP precedence values must match.
— identifies the class map.
Enter a MAC ACL name. Its contents is used as the match
criteria in the class map.
Quality of Service (QoS)