Dcbx Version - Dell MXL 10GbE Reference Manual

Command
Version 9.3.0.0
History
Usage
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Information
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.

dcbx version

Configure the DCBX version used on the interface.
Syntax
dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the dcbx version {auto | cee | cin |
ieee-v2.5} command.
Parameters
auto | cee | cin
| ieee-v2.5
Defaults Auto
Command INTERFACE PROTOCOL LLDP
Modes
Command
Version 9.3.0.0
History
Usage
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Information
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.
debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail |
mgmt | resource | sem | tlv}
1380
Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
Enter the DCBX version type used on the interface, where:
• auto: configures the port to operate using the DCBX
version received from a peer.
• cee: configures the port to use CDD (Intel 1.01).
• cin: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
• ieee-v2: configures the port to use IEEE 802.1az (Draft
2.5).
Introduced on the FC Flex IO module installed in the M I/O
Aggregator and MXL 10/40GbE Switch
FC Flex IO Modules