Multicast - Dell MXL 10GbE Reference Manual

Multicast

The multicast commands are supported by Dell Networking Operating System (OS).
This chapter contains the following sections:
• IPv4 Multicast Commands
• IPv6 Multicast Commands
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent
multicast (PIM) tree information base, use the clear ip pim tib command.
Syntax
clear ip mroute {group-address [source-address] | * | snooping}
Parameters
group-address
[source-
address]
*
snooping
Command EXEC Privilege
Modes
Command
Version 9.2.
History
(0.0)
Related show ip pim tib
Commands
912
Enter the multicast group address and source address (if
desired), in dotted decimal format, to clear information on a
specific group.
Enter * to clear all multicast routes.
Enter the keyword snooping to delete multicast snooping
route table entries.
Introduced on the MXL 10/40GbE Switch IO Module.
— shows the PIM tree information base.
35
Multicast