Isis Metric - Dell MXL 10GbE Reference Manual

Usage
Dell Networking recommends configuring metrics on all interfaces. Without
Information
configuring this command, the IS-IS metrics are similar to hop-count metrics.

isis metric

Assign a metric to an interface.
Syntax
isis metric default-metric [level-1 | level-2]
To return to the default values, use the no isis metric [default-metric]
[level-1 | level-2] command.
Parameters
default-metric
level-1
level-2
Defaults default-metric = 10; level-1 (if not otherwise specified)
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Usage
Dell Networking recommends configuring metrics on all interfaces. Without
Information
configuring this command, the IS-IS metrics are similar to hop-count metrics.
isis network point-to-point
Enable the software to treat a broadcast interface as a point-to-point interface.
Syntax
isis network point-to-point
To disable the feature, use the no isis network point-to-point command.
814
Metric assigned to the link and used to calculate the cost
from each other router via the links in the network to other
destinations. You can configure this metric for Level 1 or
Level 2 routing. The range is from 0 to 63 for narrow and
transition metric styles and from 0 to 16777215 for wide
metric styles. The default is 10.
(OPTIONAL) Enter the keywords level-1 to configure the
shortest path first (SPF) calculation for Level 1 (intra-area)
routing. This setting is the default.
(OPTIONAL) Enter the keywords level-2 to configure the
SPF calculation for Level 2 (inter-area) routing.
Introduced on the MXL 10/40GbE Switch IO Module.
Intermediate System to Intermediate System (IS-IS)