Dell MXL 10GbE Reference Manual page 1200

Command
Version 9.5(0.0)
History
Related userrole, username
Commands
ssh
Open an SSH connection specifying the host name, username, port number and version of the SSH
client.
Syntax
ssh {hostname | ipv4 address} [-l username | -p port-number | -
v {1 | 2}]
Parameters
hostname
ipv4 address
-l username
-p port-
number
-v {1 | 2}
Defaults As shown in the Parameters section.
Command EXEC Privilege
Modes
Command
Version 8.3.16.1
History
Usage The system supports both inbound and outbound SSH sessions using IPv4 or IPv6
Information addressing. Inbound SSH supports accessing the system through the management
interface as well as through a physical Layer 3 interface.
Example
Dell#ssh 10.16.151.48 -l anvltest
Trying 10.16.151.48...
01:18:16: %STKUNIT0-M:CP %SEC-5-SSH_USAGE: Initiated SSH
Client v2 (FIPS Disabled) to anvltest@10.16.151.48 by default
from console
anvltest@10.16.151.48's password:
Last login: Thu Jan
[anvltest@dt-maa-linux-1 ~]# exit
1200
Introduced on the Z9000, S6000, S4820T, S4810, MXL.
(OPTIONAL) Enter the IP address or the host name of the
remote device.
(OPTIONAL) Enter the IP address in dotted decimal format
A.B.C.D.
(OPTIONAL) Enter the keyword -l then the user name used
in this SSH session. The default is the user name of the user
associated with the terminal.
(OPTIONAL) Enter the keyword -p then the port number.
The range is from 1 to 65536. The default is 22.
(OPTIONAL) Enter the keyword -v then the SSH version 1 or
2. The default is the version from the protocol negotiation.
Introduced on the MXL 10/40GbE Switch IO Module.
5 00:17:47 2012 from login-maa-101
Security