Show Isis Database - Dell MXL 10GbE Reference Manual

clns host ISIS 49.0000.0001.F100.E120.0013.00
log-adjacency-changes
net 49.0000.0001.F100.E120.0013.00
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family
Example
The bold section identifies that Multi-Topology IS-IS is enabled in Transition mode.
(Address-
Dell(conf-router_isis-af_ipv6)#show conf
Family_IPv6)
!
address-family ipv6 unicast
maximum-paths 16
multi-topology transition
set-overload-bit
spf-interval level-1 100 15 20
spf-interval level-2 120 20 25
exit-address-family

show isis database

Display the IS-IS link state database.
Syntax
show isis database [level-1 | level-2] [local] [detail |
summary] [lspid]
Parameters
level-1
level-2
local
detail
summary
lspid
Command
•
Modes
•
Command
Version 9.2(0.0)
History
830
(OPTIONAL) Displays the Level 1 IS-IS link-state database.
(OPTIONAL) Displays the Level 2 IS-IS link-state database.
(OPTIONAL) Displays local link-state database information.
(OPTIONAL) Detailed link-state database information of each
LSP displays when specified. If not specified, a summary
displays.
(OPTIONAL) Summary of link-state database information
displays when specified.
(OPTIONAL) Display only the specified LSP.
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
Intermediate System to Intermediate System (IS-IS)