Interface Loopback - Dell MXL 10GbE Reference Manual

Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.4(0.0)
History
Version 9.2(0.0)
Version 8.3.16.1
Usage
You cannot delete a physical interface.
Information
By default, physical interfaces are disabled (shutdown) and are in Layer 3 mode. To
place an interface in mode, ensure that the interface's configuration does not
contain an IP address and enter the Port Channel Commands command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the
next hop to the tunnel destination is over a physical interface. If you select any
other interface as the next hop to the tunnel destination, the tunnel interface does
not operate as an ECMP.
Example
Dell(conf)#interface tengig 0/0
Dell(conf-if-tengig-0/0)#exit#
Related
interface port-channel
Commands
interface vlan
show interfaces

interface loopback

Configure a Loopback interface.
Syntax
interface loopback number
To remove a loopback interface, use the no interface loopback number
command.
562
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Fibre Channel interface, enter the keyword
FibreChannel, then the slot/port information.
Added the support for interfaces.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— configures a port channel.
— configures a VLAN.
— displays the interface configuration.
Interfaces