Snmp-Server Location - Dell MXL 10GbE Reference Manual

snmp-server enable command and the snmp-server host command for that
host must be enabled.
Configuring Informs
To send an inform, use the following steps:
1.
2.
3.
4.
5.
Related
snmp-server enable traps
Commands
snmp-server community

snmp-server location

Configure the location of the SNMP server.
Syntax
snmp-server location text
To delete the SNMP location, use the no snmp-server location command.
Parameters
text
Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Simple Network Management Protocol (SNMP) and Syslog
NOTE: For v1 / v2c trap configuration, if the community-string is not defined
using the snmp-server community command prior to using this command,
the default form of the snmp-server community command automatically is
configured with the community-name the same as specified in the snmp-
server host command.
Configure a remote engine ID.
Configure a remote user.
Configure a group for this user with access rights.
Enable traps.
Configure a host to receive informs.
— enables SNMP traps.
— configures a new community SNMPv1 or SNMPv2c.
Enter an alpha-numeric text string, up to 55 characters long.
Introduced on the MXL 10/40GbE Switch IO Module.
1233