Group - Dell MXL 10GbE Reference Manual

Related
description
Commands
interface port-channel
shutdown

group

Group two LAGs in a supergroup ("fate-sharing group" or "failover group").
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number
command.
Parameters
group_number
port-channel
number
Defaults none
Command PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Examle
Dell(conf)#port-channel failover-group
Dell(conf-po-failover-grp)#group 1 port-channel 1 port-channel
2
Dell(conf-po-failover-grp)#
Related
port-channel failover-group
Commands
mode to configure a LAG failover group.
show interfaces port-channel
groups.
Interfaces
— assigns a descriptive text string to the interface.
— creates a Port Channel interface.
— disables/enables the port channel.
Enter an integer from 1 to 32 that uniquely identifies this LAG
fate-sharing group.
Enter the keywords port-channel then an existing LAG
number. Enter this keyword/variable combination twice,
identifying the two paired LAGs.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
— accesses PORT-CHANNEL FAILOVER-GROUP
— displays information on configured Port Channel
601