Lacp Long-Timeout - Dell MXL 10GbE Reference Manual

events
pdu
interface in |
out
Defaults none
Command
•
Modes
•
Command
Version 8.3.16.1
History

lacp long-timeout

Configure a long timeout period (30 seconds) for an LACP session.
Syntax
lacp long-timeout
To reset the timeout period to a short timeout (1 second), use the no lacp long-
timeout command.
Defaults 1 second
Command INTERFACE (conf-if-po-number)
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage This command applies to dynamic port-channel interfaces only. When applied on a
Information static port-channel, this command has no effect.
Link Aggregation Control Protocol (LACP)
(OPTIONAL) Enter the keyword events to debug the LACP
event information.
(OPTIONAL) Enter the keyword pdu to debug the LACP
Protocol Data Unit information.
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a Ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Optionally, enter an in or out parameter:
• Receive enter in
• Transmit enter out
EXEC
EXEC Privilege
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
841