Dell MXL 10GbE Reference Manual page 1537

Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Related show logging
Commands buffer.
logging
Configure an IP address or host name of a Syslog server where logging messages are sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
Syntax
logging {ip-address | ipv6-address | hostname} [vrf vrf-name]
To disable logging, use the no logging command.
Parameters
ip-address
ipv6-address
hostname
Defaults Disabled.
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
— displays logging settings and system messages in the internal
Enter the IPv4 address in dotted decimal format.
Enter the IPv6 address in the x:x:x:x::X format.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the name of a host already configured and recognized
by the switch.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
1537