Duplex (1000/10000 Interfaces) - Dell MXL 10GbE Reference Manual

Defaults none
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
Important Points to Remember:
Information
•
•
•
•
Related show interfaces description
Commands

duplex (1000/10000 Interfaces)

Configure duplex mode on any physical interfaces where the speed is set to 1000/10000.
Syntax
duplex {half | full}
To return to the default setting, use the no duplex command.
Parameters
half
full
Defaults Not configured.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
558
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Spaces between characters are not preserved after entering this command
unless you enclose the entire description in quotation marks ("desc_text").
Entering a text string after the description command overwrites any previous
text string that you previously configured as the description.
The shutdown and description commands are the only commands that you
can configure on an interface that is a member of a port-channel.
Use the show interfaces description command to display descriptions
configured for each interface.
Enter the keyword half to set the physical interface to
transmit only in one direction.
Enter the keyword full to set the physical interface to
transmit in both directions.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— displays the description field of the interfaces.
Interfaces