Dell MXL 10GbE Reference Manual page 657

Parameters
name
ah-
authentication
esp-
authentication
esp-encryption
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Usage
•
Information
•
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
Internet Protocol Security (IPSec)
Enter the name for the transform set.
Enter the keywords ah-authentication then the
transform type of operation to apply to traffic. The transform
type represents the encryption or authentication applied to
traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1)
authentication.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
Enter the keywords esp-authentication then the
transform type of operation to apply to traffic. The transform
type represents the encryption or authentication applied to
traffic.
• md5 — Use Message Digest 5 (MD5) authentication.
• sha1 — Use Secure Hash Algorithm 1 (SHA-1)
authentication.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
Enter the keywords esp-encryption then the transform
type of operation to apply to traffic. The transform type
represents the encryption or authentication applied to traffic.
• 3des — Use 3DES encryption.
• cbc — Use CDC encryption.
• des — Use DES encryption.
• null — Causes an encryption policy configured for the
area to not be inherited on the interface.
Introduced on the MXL 10/40GbE Switch IO Module.
Both sides of the link must specify the same transform set.
You can create up to 64 transform sets.
657