Show Dcb - Dell MXL 10GbE Reference Manual

show dcb

Displays the data center bridging status, the number of PFC-enabled ports, and the number of PFC-
enabled queues.
Syntax
show dcb [stack-unit unit-number]
Parameters
unit number
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage Specify a stack-unit number on the Master switch in a stack.
Information
Example
Dell(conf)#do show
stack-unit 0 port-set 0
DCB Status
PFC Queue Count
Total Buffer[lossy + lossless] (in KB):7982
PFC Total Buffer (in KB)
PFC Shared Buffer (in KB)
PFC Available Buffer (in KB)
Dell (conf)#
show interface dcbx detail
Displays the DCBX configuration on an interface.
Syntax
show interface port-type slot/port dcbx detail
Parameters
port-type
slot/port
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
To clear DCBX frame counters, use the clear dcbx counters interface
Information
stack-unit/port command.
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Enter the DCB unit number. The range is from 0 to 5.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
dcb
:Enabled
:2
Enter the port type.
Enter the slot/port number.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
:5872
:832
:4860
1443