Ipv6 Ospf Bfd All-Neighbors - Dell MXL 10GbE Reference Manual

Defaults Not configured.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Usage
Before you enable IPsec authentication on an OSPFv3 interface, first enable IPv6
Information
unicast routing globally, configure an IPv6 address and enable OSPFv3 on the
interface, and assign the interface to an area.
An SPI value must be unique to one IPsec security policy (authentication or
encryption) on the router. Configure the same authentication policy (same SPI and
key) on each OSPFv3 interface in a link.

ipv6 ospf bfd all-neighbors

Establish BFD sessions with all OSPFv3 neighbors on a single interface or use non-default BFD session
parameters.
Syntax
ipv6 ospf bfd all-neighbors [disable | [interval interval
min_rx min_rx multiplier value role {active | passive}]]
To disable all BFD sessions on an OSPFv3 interface implicitly, use the no ipv6
ospf bfd all-neighbors disable command.
Parameters
disable
interval
milliseconds
min_rx
milliseconds
multiplier value
990
For MD5 authentication, the key must be 32 hex digits (non-
encrypted) or 64 hex digits (encrypted).
For SHA-1 authentication, the key must be 40 hex digits
(non-encrypted) or 80 hex digits (encrypted).
Introduced on the MXL 10/40GbE Switch IO Module.
(OPTIONAL) Enter the keyword disable to disable BFD on
this interface.
(OPTIONAL) Enter the keyword interval to specify non-
default BFD session parameters beginning with the
transmission interval. The range is from 50 to 1000. The
default is 100.
Enter the keywords min_rx to specify the minimum rate at
which the local system would like to receive control packets
from the remote system. The range is from 50 to 100. The
default is 100.
Enter the keyword multiplier to specify the number of
packets that must be missed in order to declare a session
down. The range is from 3 to 50. The default is 3.
Open Shortest Path First (OSPFv2 and OSPFv3)