Mac-Address-Table Static - Dell MXL 10GbE Reference Manual

Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1

mac-address-table static

Associate specific MAC or hardware addresses to an interface and virtual local area networks (VLANs).
Syntax
mac-address-table static mac-address output interface vlan
vlan-id
To remove a MAC address, use the no mac-address-table static mac-
address output interface vlan vlan-id command.
Parameters
mac-address
output
interface
vlan vlan-id
Defaults Not configured.
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
mac-address-table station-move refresh-arp
Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs
due to a topology change.
Syntax
[no] mac-address-table station-move refresh-arp
1492
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn
format.
Enter the keyword output then one of the following
interfaces for which traffic is forwarded:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
Enter the keyword vlan then a VLAN ID number from 1 to
4094.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
PMUX Mode of the MXL 10/40GbE Switch I/O Module