Minimum-Links - Dell MXL 10GbE Reference Manual

minimum-links

Configure the minimum number of links in a LAG (Port Channel) that must be in "oper up" status for the
LAG to be also in "oper up" status.
Syntax
minimum-links number
Parameters
number
Defaults 1
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
If you use this command to configure the minimum number of links in a LAG that
Information
must be in "oper up" status, the LAG must have at least that number of "oper up"
links before it can be declared as up. For example, if the required minimum is four,
and only three are up, the LAG is considered down.
port-channel failover-group
To configure a LAG failover group, access PORT-CHANNEL FAILOVER-GROUP mode.
Syntax
port-channel failover-group
To remove all LAG failover groups, use the no port-channel failover-group
command.
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage
This feature groups two LAGs to work in tandem as a supergroup. For example, if
Information
one LAG goes down, the other LAG is taken down automatically, providing an
alternate path to reroute traffic, avoiding oversubscription on the other LAG. You
can use both static and dynamic (LACP) LAGs to configure failover groups. For
Interfaces
Enter the number of links in a LAG that must be in "oper up"
status. The range is from 1 to 16. The default is 1.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
603