Table of Contents
Advertisement
Defaults
Enabled.
Command
CONFIGURATION
Modes
Command
Version 8.3.16.1
History
Usage
When you use the no logging on command, messages are logged only to the
Information
console.
Related
logging
Commands
logging buffered
logging console
logging monitor
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog
server.
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging
source-interface command.
Parameters
interface
Defaults
Not configured.
Command
CONFIGURATION
Modes
1248
Introduced on the MXL 10/40GbE Switch IO Module.
— enables logging to the Syslog server.
— sets the logging buffered parameters.
— sets the logging console parameters.
— sets the logging parameters for the terminal connections.
Enter the following keywords and slot/port or number
information:
•
For Loopback interfaces, enter the keyword loopback
then a number from zero (0) to 16383.
•
For a Port Channel interface, enter the keywords port-
channel then a number. Tthe range is from 1 to 128.
•
For a ten-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
•
For VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
Simple Network Management Protocol (SNMP) and Syslog
Advertisement
Table of Contents
