Keepalive - Dell MXL 10GbE Reference Manual

When you apply an FCoE map to a server-facing Ethernet port, the port is
automatically configured as a tagged member of the FCoE VLAN.
For more information about VLANs and the commands to configure them, refer to
the
Example (Single
FTOS(conf)#interface vlan 10
Range)
FTOS(conf-if-vl-3)#
Related
fcoe-map
Commands
communication between servers and a SAN fabric.
show
FCoE maps.

keepalive

In an FCoE map, enable the monitoring of FIP keepalive messages (if it is disabled).
M I/O Aggregator and MXL 10/40GbE Switch with the FC Flex IO module
Syntax
keepalive
Parameters None
Defaults FIP keepalive monitoring is enabled on Ethernet and Fibre Channel interfaces.
Command FCOE MAP
Modes
Command
Version 9.3(0.0)
History
Usage
FIP keepalive (FKA) messaging is used to detect if other FCoE devices are reachable.
Information
To remove FIP keepalive monitoring from an FCoE map, enter the no keepalive
command.
Related
fcoe-map
Commands
communication between servers and a SAN fabric.
show
FCoE maps.
FC Flex IO Modules
Virtual LAN (VLAN) Commands
— creates an FCoE map which contains the parameters used in the
fcoe-map— displays the Fibre Channel and FCoE configuration parameters in
Introduced on the M I/O Aggregator and MXL 10/40GbE
Switch with the FC Flex IO module.
— creates an FCoE map which contains the parameters used in the
fcoe-map— displays the Fibre Channel and FCoE configuration parameters in
section of the Layer 2 chapter.
1413