Vlt-Peer-Lag Port-Channel - Dell MXL 10GbE Reference Manual

Version 9.2(0.0)
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.8.0
Usage The VLT domain ID must be the same between the two VLT devices. If the domain
Information ID is not the same, a syslog message is generated and VLT does not launch.
Related show vlt brief
Commands value.

vlt-peer-lag port-channel

Associate the port channel to the corresponding port channel in the VLT peer for the VLT connection to
an attached device.
Syntax
vlt-peer-lag port-channel id-number
Parameters
id-number
Defaults Not configured.
Command INTERFACE PORT-CHANNEL
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.8.0
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
— uses the show vlt brief command to display the delay-restore
Enter the respective vlt port-channel number of the peer
device.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
1517