Table of Contents
Advertisement
Defaults
As above.
Command
CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.1(0.0)
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.4.1.0
Version 7.6.1.0
Version 7.5.1.0
E-Series legacy
command
Usage
In order to configure the router to send SNMP notifications, enter at least one
Information
snmp-server host command. If you enter the command with no keywords, all
trap types are enabled for the host. If you do not enter an snmp-server host
command, no notifications are sent.
In order to enable multiple hosts, issue a separate snmp-server host command
for each host. You can specify multiple notification types in the command for each
host.
When multiple snmp-server host commands are given for the same host and
type of notification (trap or inform), each succeeding command overwrites the
PMUX Mode of the MXL 10/40GbE Switch I/O Module
•
isis — Enable ISIS adjacency change traps
•
pfc — Enable pfc traps
•
snmp — Enable SNMP trap
•
stp — Enable 802.1d state change traps
•
vlt — Enable VLT traps
•
vrrp — Enable VRRP state change traps
•
xstp — Enable 802.1s, 802.1w, and PVST+ state change
traps
The default is all trap types are sent to host.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Added support for config and ecmp traps.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for VRRP traps.
Added support for STP and xSTP notification types.
Introduced on the S-Series.
Introduced on the C-Series.
1535
Advertisement
Table of Contents
