hash-mask-
length
priority
Defaults
Not configured.
Command
CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
ip pim dr-priority
Change the designated router (DR) priority for the interface.
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority
command.
Parameters
priority-value
Defaults
1
Command
INTERFACE
Modes
Command
Version 9.2(0.0)
History
Usage
The router with the largest value assigned to an interface becomes the designated
Information
router. If two interfaces contain the same designated router priority value, the
interface with the largest interface IP address becomes the designated router.
1016
•
For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
•
For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
•
For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
•
For a VLAN, enter the keyword vlan then a number from
1 to 4094.
(OPTIONAL) Enter the hash mask length. The range is from
zero (0) to 32. The default is 30.
(OPTIONAL) Enter the priority used in Bootstrap election
process. The range is from zero (0) to 255. The default is
zero (0).
Introduced on the MXL 10/40GbE Switch IO Module.
Enter a number. Preference is given to larger/higher number.
The range is from 0 to 4294967294. The default is 1.
Introduced on the MXL 10/40GbE Switch IO Module.
PIM-Sparse Mode (PIM-SM)