Dcb-Policy Output - Dell MXL 10GbE Reference Manual

To remove only the DCB input policies applied to the specified switch, use the no
dcb-policy input stack-unit command.
Parameters
stack-unit-id
dcb-input-
policy-name
Defaults none
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage The dcb-policy input stack-unit all command overwrites any previous
Information
dcb-policy input stack-unit stack-unit-id configurations. Similarly, a
dcb-policy input stack-unit stack-unit-id command overwrites any
previous dcb-policy input stack-unit all configuration.
Related dcb-policy output stack-unit stack-ports all
Commands policy.

dcb-policy output

Apply the output policy with the ETS configuration to an egress interface.
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
policy-name
Defaults none
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Enter the stack unit identification.
Enter the policy name for the DCB input policy.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
NOTE: Please note that Dell Networking does not recommended to use this
command as it has been deprecated in the current 9.4.(0.0) release. A warning
message appears when you try to run this command indicating that you have
to use the dcb-map commands in the future.
Enter the output policy name.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— applies the specified DCB output
1427