Fip-Snooping Enable - Dell MXL 10GbE Reference Manual

Command
Version 9.2(0.0)
History
Version 8.3.16.1

fip-snooping enable

Enable FIP snooping on all VLANs or on a specified VLAN.
Syntax
fip-snooping enable
To disable the FIP snooping feature on all or a specified VLAN, use the no fip-
snooping enable command.
Defaults FIP snooping is disabled on all VLANs.
Command
•
Modes
•
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
Information The maximum number of FIP snooping sessions supported per ENode server is 16.
fip-snooping fc-map
Configure the FC-MAP value FIP snooping uses on all VLANs.
Syntax
fip-snooping fc-map fc-map-value
To return the configured FM-MAP value to the default value, use the no fip-
snooping fc-map command.
Parameters
fc-map-value
Defaults 0x0EFC00
Command
•
Modes
•
Command
Version 9.2(0.0)
History
1458
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
CONFIGURATION
VLAN INTERFACE
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the FC-MAP value FIP snooping uses. The range is
from 0EFC00 to 0EFCFF.
CONFIGURATION
VLAN INTERFACE
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
PMUX Mode of the MXL 10/40GbE Switch I/O Module