Vlt Domain - Dell MXL 10GbE Reference Manual

Parameters
0 | 1
Defaults Automatically assigned based on the MAC address of each VLT peer. The peer with
the lower MAC address is assigned unit 0; the peer with the higher MAC address is
assigned unit 1.
Command

VLT DOMAIN

Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.0)
Version 9.0.2.0
Version 9.0.0.0
Version
8.3.19.0
Version 8.3.8.0
Usage
When you create a VLT domain on a switch, Dell Networking OS automatically
Information
assigns a unique unit ID (0 or 1) to each peer switch. The unit IDs are used for
internal system operations. Use the unit-id command to explicitly configure the
unit ID of a VLT peer. Configure a different unit ID (0 or 1) on each peer switch.
To minimize the time required for the VLT system to determine the unit ID assigned
to each peer switch when one peer reboots, use this command.
vlt domain
Enable VLT on a switch, configure a VLT domain, and enter VLT-domain configuration mode.
Syntax
vlt domain domain-id
Parameters
domain-id
Command CONFIGURATION
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1516
Configure the default unit ID of a VLT peer switch. Enter 0
for the first peer or enter 1 for the second peer.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Enter the Domain ID number. Configure the same domain ID
on the peer switch. The range of domain IDs is from 1 to
1000.
PMUX Mode of the MXL 10/40GbE Switch I/O Module