Max-Area-Addresses - Dell MXL 10GbE Reference Manual

state database corruption can persist at the cost of increased link utilization. A
higher value reduces the link utilization the flooding of refreshed packets causes.
Related max-lsp-lifetime
Commands refreshed.

max-area-addresses

Configure manual area addresses.
Syntax
max-area-addresses number
To return to the default values, use the no max-area-addresses command.
Parameters
number
Defaults 3 addresses
Command ROUTER ISIS
Modes
Command
Version 9.2(0.0)
History
Usage To configure the number of area addresses on router, use this command. This
Information value must be consistent with routers in the same area, otherwise the router forms
only Level 2 adjacencies. The value must be same among all the routers to form
Level 1 adjacencies.
max-lsp-lifetime
Set the maximum time that link-state packets (LSPs) exist without being refreshed.
Syntax
max-lsp-lifetime seconds
To restore the default time, use the no max-lsp-lifetime command.
Parameters
seconds
Defaults 1200 seconds
820
— sets the maximum interval that LSPs persist without being
Set the maximum number of manual area addresses. The
range is from 3 to 6. The default is 3.
Introduced on the MXL 10/40GbE Switch IO Module.
The maximum lifetime of LSP in seconds. This value must be
greater than the lsp-refresh-interval command. The
higher the value the longer the LSPs are kept. The range is
from 1 to 65535. The default is 1200.
Intermediate System to Intermediate System (IS-IS)