Fip-Snooping Port-Mode Fcf - Dell MXL 10GbE Reference Manual

Version 8.3.16.1

fip-snooping port-mode fcf

Configure the port for bridge-to-FCF links.
Syntax
fip-snooping port-mode fcf
To disable the bridge-to-FCF link on a port, use the no fip-snooping port-
mode fcf command.
Command INTERFACE
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
Information
iSCSI Optimization
Internet small computer system interface (iSCSI) optimization enables quality-of-service (QoS) treatment
for iSCSI storage traffic.
To configure and verify the iSCSI optimization feature, use the following Dell Networking Operating
System (OS) commands.
advertise dcbx-app-tlv
Configure DCBX to send iSCSI TLV advertisements.
Syntax
advertise dcbx-app-tlv iscsi
To disable DCBX iSCSI TLV advertisements, use the no advertise dcbx-app-
tlv iscsi command.
Defaults Disabled.
Command PROTOCOL LLDP
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
PMUX Mode of the MXL 10/40GbE Switch I/O Module
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
1459