Match Ip Vrf - Dell MXL 10GbE Reference Manual

Parameters
vlan vlan-id
Defaults none
Command CONF-CLASS-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0)
Usage To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria.
Use this command to match an IP class-map against a single VLAN ID .
Related class-map
Commands

match ip vrf

Uses a VRF as the match criterion for an L3 class map.
Syntax
match ip vrf vrf-id
To remove VRF as the match criterion, use the no match ip vrf vrf-id
command.
Parameters
vlan vlan-id
Defaults none
Command CONF-CLASS-MAP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4(0.0)
Usage To access this command, enter the class-map command. After the class map is
Information
identified, you can configure the match criteria.
Quality of Service (QoS)
Enter the keyword vlan and then the ID of the VLAN. The
range is from 1 to 4094.
Introduced on the MXL switch.
— identifies the class map.
Enter the keyword vrf and then the ID of the VRF. The range
is from 1 to 63.
Introduced on the MXL switch.
1083