Network Backdoor - Dell MXL 10GbE Reference Manual

Parameters
ipv6-address
prefix-length
mask
route-map
map-name
Defaults Not configured.
Command ROUTER BGPV6-ADDRESS FAMILY
Modes
Command
Version 9.2(0.0)
History
Usage The software resolves the network address configured by the network command
Information with the routes in the main routing table to ensure that the networks are reachable
using non-BGP routes and non-default routes.
Related redistribute
Commands

network backdoor

Specify this IGP route as the preferred route.
Syntax
network ipv6-address prefix-length backdoor
To remove a network, use the no network ipv6-address prefix-length
backdoor command.
Parameters
ipv6-address
prefix-length
Defaults Not configured.
740
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Enter the mask of the IP address in the slash prefix length
format (for example, /24). The mask appears in command
outputs in dotted decimal format (A.B.C.D).
(OPTIONAL) Enter the keywords route-map then the name
of an established route map.
If the route map is not configured, the default is deny (to
drop all routes).
Introduced on the MXL 10/40GbE Switch IO Module.
— redistributes routes into BGP.
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
IPv6 Border Gateway Protocol (IPv6 BGP)