Ipv6 Control-Plane Egress-Filter - Dell MXL 10GbE Reference Manual

ospfv3
Defaults All access lists contain an implicit "deny any"; that is, if no match occurs, the packet
is dropped.
Command CONFIGURATION
Modes
Command
Version 9.4(0.0)
History
Version 9.2(0.0)
Usage The number of entries allowed per ACL is hardware-dependent. For detailed
Information specification on entries allowed per ACL, refer to your line card documentation.
You can create an IPv6 ACL for control-plane traffic policing for OSPFv3, in
addition to the CoPP support for VRRP, BGP, and ICMP that existed in Dell
Networking OS releases 9.3(0.0) and earlier
Related show config
Commands

ipv6 control-plane egress-filter

Enable egress Layer 3 ACL lookup for IPv6 CPU traffic.
Syntax
ipv6 control-plane egress-filter
Defaults Not enabled.
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
permit
To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or
UDP.
Syntax
permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} [count
[byte]] [dscp value] [order] [fragments] [log [interval
minutes] [threshold-in-msgs [count]] [monitor]
To remove this filter, you have two choices:
•
IPv6 Access Control Lists (IPv6 ACLs)
Specify that this ACL is for OSPFv3 control plane traffic
Added support for CoPP for OSPFv3 on the MXL 10/40GbE
Switch IO Module.
Introduced on the MXL 10/40GbE Switch IO Module.
— views the current configuration.
Introduced on the MXL 10/40GbE Switch IO Module.
Use the no seq sequence-number command syntax if you know the filter's
sequence number
667