Ipv6 Basics - Dell MXL 10GbE Reference Manual

IPv6 Basics

This chapter describes IPv6 basic commands for the MXL 10/40GbE Switch IO Module.
clear ipv6 fib
Clear (refresh) all forwarding information base (FIB) entries on a linecard or stack unit.
Syntax
clear ipv6 fib linecard slot | stack-unit unit-number
Parameters
slot
unit-number
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
clear ipv6 route
Clear (refresh) all or a specific route from the IPv6 routing table.
Syntax
clear ipv6 route {* | ipv6-address prefix-length}
Parameters
*
ipv6-address
prefix-length
Command EXEC Privilege
Modes
Command
Version 9.2(0.0)
History
IPv6 Basics
Enter the slot number to clear the FIB for a linecard.
Enter the stack member number.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the * to clear (refresh) all routes from the IPv6 routing
table.
Enter the IPv6 address in the x:x:x:x::x format then the prefix
length in the /x format. The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
Introduced on the MXL 10/40GbE Switch IO Module.
25
673