Vlan-Stack Dot1P-Mapping - Dell MXL 10GbE Reference Manual

Example
Dell#show vlan
Codes: * - Default VLAN, G - GVRP VLANs
*
Dell#

vlan-stack dot1p-mapping

Map C-Tag dot1p values to a S-Tag dot1p value. You can separate the C-Tag values by commas and
dashed ranges are permitted. Dynamic mode CoS overrides any Layer 2 QoS configuration in case of
conflicts.
Syntax
vlan-stack dot1p-mapping c-tag-dot1p values sp-tag-dot1p value
Parameters
c-tag-dot1p
value
sp-tag-dot1p
value
Defaults none
Command INTERFACE
Modes
Command
Version 8.3.16.1
History
vlan-stack protocol-type
Define the stackable VLAN tag protocol identifier (TPID) for the outer VLAN tag (also called the VMAN
tag). If you do not configure this command, the system assigns the value 0x9100.
Syntax
vlan-stack protocol-type number
VLAN Stacking
NUM Status Q Ports
1 Inactive
2 Active M Gi 13/13
M Gi 13/0-2
3 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/3
4 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/4
5 Active M Po1(Gi 13/14-15)
M Gi 13/18
M Gi 13/5
Enter the keyword c-tag-dot1p then the customer dot1p
value that is mapped to a service provider do1p value. The
range is from 0 to 5.
Enter the keyword sp-tag-dot1p then the service provider
dot1p value. The range is from 0 to 5.
Introduced on the MXL 10/40GbE Switch IO Module.
1327