Interface Null - Dell MXL 10GbE Reference Manual

Example
Dell(conf)#interface managementethernet 0/0
Dell(conf-if-ma-0/0)#

interface null

Configure a Null interface on the switch.
Syntax
interface null number
Parameters
number
Defaults Not configured; number = 0
Command CONFIGURATION
Modes
Command
Version 9.2(0.0)
History
Version 8.3.16.1
Usage You cannot delete the Null interface. The only configuration command possible in
Information a Null interface is ip unreachables.
Example
Dell(conf)#interface null 0
Dell(conf-if-nu-0)#
Related
interface
Commands
interface loopback
interface port-channel
interface vlan
ip unreachables — enables generation of internet control message protocol (ICMP)
unreachable messages.
interface range
This command permits configuration of a range of interfaces to which subsequent commands are
applied (bulk configuration). Using the interface range command, you can enter identical commands
for a range of interface.
Syntax
interface range interface, interface,...
564
Enter zero (0) as the Null interface number.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the MXL 10/40GbE Switch IO Module.
— configures a physical interface.
— configures a Loopback interface.
— configures a port channel.
— configures a VLAN.
Interfaces