Protocol Lldp (Interface) - Dell MXL 10GbE Reference Manual

protocol lldp (Interface)

Enter the LLDP protocol in INTERFACE mode.
Syntax
[no] protocol lldp
To return to the global LLDP configuration mode, use the no protocol lldp
command from Interface mode.
Defaults LLDP is not enabled on the interface.
Command INTERFACE (conf-if-interface-lldp)
Modes
Command
Version 8.3.16.1
History
Usage
Before LLDP can be configured on an interface, it must be enabled globally from
Information
CONFIGURATION mode. This command places you in LLDP mode on the
interface; it does not enable the protocol.
When you enter the LLDP protocol in the Interface context, it overrides global
configurations. When you execute the no protocol lldp from INTERFACE
mode, interfaces begin to inherit the configuration from global LLDP
CONFIGURATION mode.
show lldp neighbors
Display LLDP neighbor information for all interfaces or a specified interface.
Syntax
show lldp neighbors [interface] [detail]
Parameters
interface
detail
Defaults none
Command EXEC Privilege
Modes
872
(OPTIONAL) Enter the following keywords and slot/port or
number information:
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
(OPTIONAL) Enter the keyword detail to display all the TLV
information, remote management IP addresses, timers, and
LLDP tx and rx counters.
Link Layer Discovery Protocol (LLDP)